The images below show the capped off harness connector that is clipped inside fo the left Rally fairing. Simply release the protective caps retaining clip, remove the cap and plug in the MOTO STUFF harness and now you have a factory looking 10 amp switched accessory lead!
HONDA was nice enough to include a handy 10 AMP* switched accessory lead that is clipped inside the left front fairing, however they have yet to release an accessory lead to plug into it! So we picked up the ball and sourced the correct original HONDA waterproof connectors and built a version featuring the innovative posi loc connectors to allow you to connect just about any electrical accessory you'd like without thneedd for cutting, splicing or soldering! The harness leads are 18" long and allow for safe routing from the left upper fairing, following the factory harness routing to the Rally tower.
Our plug and play accessory lead is easy to install, just unclip the stock connector cap, connect this lead and attach to your accessory with the included posi lock quick connectors! Posi Lock instructions are included in each kit.
Kit includes 18" 2 circuit lead ( 18 gauge red 12V+ and Black ground) terminated with Posi Lock connectors with abrasion sheath and 2 black zip ties for secure installation. Posi-Lock® Connectors have been put the to test worldwide since 1997. Superior in-line splices with just hand tightening! These electrical connectors require no crimping or soldering. An electrical connector that meets the needs of todays OEM's, and is so good, it's reusable. Truly a connector for the 21st century.
* This is a 10 AMP Switched circuit (fuse #5 on the Rally), which means it is turned off and on by the bikes ignition switch.
Here's a short list of the average current draw for popular accessories:
Heated Grips 3-5 AMPS
USB Phone Charger 1-2 AMPS
Heated Gloves 3 AMPS
Heated Jacket 8 AMPS
Heated Pants 6 AMPS
WARNING:Most High output horns will draw too much amperage for this circuit